Flanked Rectangular Onyx Wall Light

Flanked Rectangular Onyx Wall Light
Product Introduction:
The flanked rectangular onyx wall light clamps a single translucent onyx slab between two solid metal uprights, open at the top and bottom. The stone carries the light and the flanks frame it on both sides, so the fixture reads as a lit rectangle set into the wall rather than something added to it.
Rating: 4.7
(8 ratings)
Send Inquiry
Add To Inquiry
Description
Technical Parameters

The flanked rectangular onyx wall light is made of three parts: the stone slab, the two metal flanks and the concealed body that carries the light. The flanks are deeper than the stone, so the panel sits in a shallow recess and its edges stay protected; the screws at the base are visible by design, because the panel is serviced from below without dismantling the light.

The stone carries the light. Veins run through the slab at different densities, so the panel is brightest where the stone is thin and softer where it is thick. That unevenness is why a natural slab is used instead of an opal diffuser: the wall behind picks up a warm, slightly mottled wash, and the surface still shows its pattern when the light is off.

The fixture is rectangular and vertical, which suits places where a wall light has to sit between other elements: a stair stringer, a run of timber panelling, the edge of a window reveal. Mounted at one height on both sides of a corridor, a pair holds the rhythm of the space.

In daylight the panel reads as a pale stone plaque with visible veining and a metal edge on each side; after dark the same stone becomes a soft light source and the wall around it takes on a warm halo. That change is why the fixture works both in corridors where the wall is the main finish and in rooms where the light is the only decoration.

Product Parameter

Model JSP-MB3319
Product Type Wall Lamp
Application Areas Living Rooms, Stairwells, Corridors
Main Material Natural Translucent Onyx, Metal
Product Color Brass-Tone Frame, Off-White Stone

Start Your Custom Project

The flanked rectangular onyx wall light can be adjusted within the following items, with the elevation and the wall build-up used to confirm the final set.

1. Panel size and proportion: slab height and width follow the wall area and the fixing line.

2. Stone selection: colour, veining and translucency are confirmed from samples, and panels for one run are cut from the same block where possible.

3. Flank metal and finish: flank depth and finish can be assessed from a sample.

4. Light source and electrical: power, colour temperature and voltage are confirmed per project rather than fixed in advance.

5. Installation: wall build-up, fixing points and cable position are checked against the site before production.

6. Packing: stone slabs are packed separately with edge protection, and the metal parts are packed as a set.

7. Process: elevation drawing, stone sample, then quotation and production.

Product application scenario

Onyx wall light mounted in a timber-lined corner with a window to the left
Wall Light in a Timber Corner
Onyx wall light seen from a wider angle beside a tall window and vertical timber panelling
Proportion against Window and Panelling

Product process details

Close-up of the lower half of an onyx wall light with veined stone and two screws at the base
Lower Panel and Screw Fixings

Real factory scenes

Certifications & Documents

Certifications and documents

FAQ

Q: Is the stone sealed at the edges?

Q: Why are the base screws visible?

Q: Can two lights match on one wall?

 

Hot Tags: flanked rectangular onyx wall light, China flanked rectangular onyx wall light factory, Bathroom Sconce with Clear Optic Glass Shade, hotel hallway lighting fixture, Hotel Square Wall Lamp, Luxury Modern Crystal Wall Lamp, New Light Luxury Corridor Lights, square exterior wall sconce for hotel

Send Inquiry